A sharp chain does the work for you. A dull one makes you push, wears out the bar and the sprocket, and is far more likely to kick back. The good news is that a chain tells you clearly when it needs attention.
Signs the chain is dull
A sharp chain throws thick chips. A dull chain makes fine dust, like flour. If you find yourself pressing down on the saw to make it cut, it is dull.
Other signs are smoke from the cut even with plenty of bar oil, a saw that pulls to one side, and a rough, bouncing cut. Hitting dirt or a stone dulls a chain in a second, so keep the tip out of the ground.
Sharpening with a file
For touch-ups in the field, a round file in the right size for your chain and a file guide are all you need. Give every cutter the same number of strokes, at the angle marked on the guide, and work from the inside of the cutter outwards.
After a few sharpenings, the depth gauges in front of each cutter need lowering too, or the chain will stop biting even though the cutters are sharp.
When to replace the chain
Replace the chain when the top plate of the cutters is worn back to about a quarter of an inch, when cutters are cracked or broken, or when one side has been ground much shorter than the other after hitting a rock.
A stretched chain that sags off the bar even after tightening also needs replacing, and so may the drive sprocket. Running a new chain on a worn sprocket wears the new chain out fast.
What we do at the shop
We sharpen chains on a grinder for $14, usually the same day, and set every depth gauge. Our chainsaw service at $59 adds a bar dressing, a sprocket check and a carburetor tune with a tachometer.
