GT Hardware · live demo with sample contentGet this themeAll demos

Mon–Fri 7:30–19:00 · Sat 8:00–18:00 · Sun 10:00–16:00 · 4521 E Superior St, Duluth, MN 55804 Call +1 (218) 555-0147

How to rescreen a window screen (and when to bring it in)

A torn screen is a twenty-minute job with the right spline and a roller. Here is how, and when the frame needs us instead.

·

A minimalistic facade featuring two modern windows with shutters in a bright, contemporary style.

Most torn window screens do not need a new frame, only new mesh and a new spline: the rubber cord that holds the mesh in the groove. With the right parts it is a twenty-minute job on the kitchen table, and the parts cost less than a sandwich.

What you need

Bring the old spline to the counter so we can match its diameter; the common sizes differ by fractions of a millimetre and the wrong one either falls out or will not go in. You also need fiberglass mesh a couple of inches bigger than the frame on every side, a spline roller and a sharp utility knife.

If you have a dog or a cat, ask for pet-resistant mesh. It is thicker, a little darker and survives claws far better than standard fiberglass.

Step by step

Pull out the old spline and mesh, and clean the groove with a screwdriver. Lay the new mesh over the frame, then use the convex wheel of the roller to press the mesh gently into the groove along one side.

Switch to the concave wheel and roll the spline in over the mesh, working around the corners without stretching the spline. Keep the mesh snug, not tight: pulling too hard bows aluminium frames inward.

Trim the extra mesh with the knife held at a low angle, just outside the spline.

When to bring it in

Bent or cracked frames, broken corner keys and wooden screen doors are better on our bench. We rescreen standard window screens from $28 and door screens from $45, usually in two days.

Winter is our quiet season, so screens dropped off between November and April come back fastest, and the off-season discount applies.

If you are not sure whether a frame is worth saving, bring it in anyway. We look at it at the counter, tell you what it needs and write the price on a tag before you decide.