Billings winters are hard on glass. A chinook can lift the temperature forty degrees in an afternoon and drop it again overnight, and every swing makes glass, frames and seals expand and shrink. A walk round the house in October finds most of the problems before the first freeze.
Look for cracks and chips
Small cracks that start at an edge spread in the cold, because the glass at the frame cools faster than the middle. A crack that was two inches in September can cross the pane by Christmas. Mark the end of a crack with tape and a date, and call us if it grows.
Check the seals
Foggy or milky glass between the panes means a failed seal, and that window now insulates little better than a single pane. Note which ones are fogged; replacing the sealed units before winter makes rooms warmer and stops ice forming on the inside.
Feel for drafts
On a windy day, run the back of your hand round each sash. A draft at the glass edge points to loose glazing; a draft where sashes meet usually needs new weatherstripping, which we fit for a few dollars a foot.
Take screens down or store them flat
Snow loads and wind tear screens left up all winter. If you take them down, store them flat in a dry place, not leaning against a wall where they bow. Drop any torn ones at the shop and they are ready the next day.
Keep humidity in check
When it is below zero outside, indoor humidity above 35 percent will frost the inside of even good windows. A cheap humidity meter in the living room tells you when to run the fans.
