A washer that stops with a tub full of water is one of the most common calls we get, and about a third of the time the fix takes ten minutes and no parts. Before you book a visit, work through these checks in order. Unplug the machine first, and keep towels and a shallow tray close by.
Check the drain hose
Pull the washer out a few inches and look at the grey drain hose at the back. If it is kinked, pinched against the wall or pushed too far down the standpipe, water cannot leave fast enough and the machine stops with an error.
The end of the hose should sit about six to eight inches into the standpipe, not sealed tight. A sealed hose can siphon water back into the drum.
Clean the pump filter
Most front-load washers have a small door at the bottom front. Behind it is a filter that catches coins, hair ties, buttons and the occasional sock. Lay towels down, open the small drain tube first if there is one, then unscrew the filter slowly.
We find something in that filter on nearly every front-loader we see. Clean it every two or three months and many drain problems never happen.
Listen to the pump
Start a drain or spin cycle and listen. A steady hum with no water moving often means the pump is blocked or its impeller is broken. Silence can mean the pump, the wiring or the control board, and that is where a meter helps.
When to call us
If the hose and filter are clear and the tub still will not empty, book a visit. A drain pump replacement starts at $165 with parts and labour, and most are done the same visit from parts in the van.
Our $69 visit and diagnosis is credited to the repair, and we give you the price before we start. If the fix turns out to be a sock, you pay the visit only.
