GT Canopy · live demo with sample contentGet this themeAll demos

Tents, tables, chairs and dance floors · Delivered and set up across Lancaster County · Mon–Fri 8:00–17:00 · Sat 9:00–13:00 Call +1 (717) 555-0148

Staked or weighted: putting a tent on grass, gravel or pavement

Why most tents are staked, when we use water barrels and concrete blocks instead, and what we need to know about your site.

·

close-up photography of green linear leafed plant

A tent is only as good as what holds it down. Before every installation we decide how the tent will be anchored, and the surface under it makes most of that decision for us.

Grass and fields: stakes

On lawns and fields we drive steel stakes, usually three to four feet long, at every leg and rope. Staking is the strongest way to hold a tent and leaves only small holes, which our crew fills when we take the tent down.

Before any stake goes in, we call 811 so the utility companies mark buried gas, electric and water lines. Private lines, such as an irrigation system, a septic field or a cable to a garden shed, are not marked by them, so please show us where yours run.

Pavement and patios: weights

On asphalt, concrete and patios we use ballast instead: water barrels or concrete blocks at each leg, sized for the tent. Weighted tents take a little longer to set up and need room for the weights around the edge.

Some parking lots can be staked with the owner’s permission, and we patch the holes afterwards. We always ask the property owner first.

Gravel and slopes

Gravel can usually be staked, but large stones slow the work, so tell us when you book. Gentle slopes are fine for a tent; a dance floor needs level ground, and on a slope we level it with a subfloor at extra cost.

What we need from you

A rough sketch or a photo of the site, the surface type, anything buried you know about and how a truck reaches the spot. For tents over 30 feet wide we visit the site before we quote, free of charge, and agree the exact position with you on the ground.