The colour is the last ten percent
Most of the paint stage is preparation: epoxy primer over bare metal, high-build primer, and hours of block sanding until the panels are straight in raking light. Then the colour, in single-stage or base and clear, cut and polished by hand.
Included
- Epoxy primer over bare metal
- Block sanding in three grits
- Factory colour code or a period colour
- Cut and polish
- Door jambs, engine bay and trunk
Typical hours
| Job | Typical hours |
|---|---|
| Complete respray after metalwork | 260–400 |
| Engine bay only | 40–60 |
| Single panel blend | 8–14 |
Questions
Can you match my original colour?
Yes. We mix from the factory paint code and spray test cards so you can compare them with an original panel in daylight.
