GT Watches · live demo with sample contentGet this themeAll demos

Tue–Fri 10:00–18:00 · Sat 10:00–16:00 · 1612 Bardstown Rd, Louisville, KY 40205 Call +1 (502) 555-0147 Request a repair →

Water resistance explained: what 30, 100 and 200 metres really mean

The number on the dial is a pressure test, not a diving depth. Here is what each rating is good for.

·

An individual diving into a clear blue swimming pool, creating splashes.

Few markings on a watch confuse people as much as the water resistance rating. A watch marked 30 metres will not survive a dive to 30 metres, and even a 200-metre diver can leak if its seals are old.

A test, not a depth

The number describes the pressure the case resisted when it was new, tested in a still tank. Swimming, diving into a pool or a jet of water from a shower adds pressure and movement the test never saw, and rubber gaskets harden with age and sunscreen.

What each rating is good for

30 metres, often written 3 bar: rain, splashes and hand washing. Take it off before a swim.

50 metres: a quick swim in calm water, but no diving or water sports. 100 metres: swimming and snorkelling, as long as the crown is screwed or pushed fully home.

200 metres and more: diving watches with screw-down crowns and thicker seals. These are the ones to wear in the sea, and they still need their seals checked.

Seals wear out

Every gasket in a watch, at the case back, the crown and the crystal, is a rubber or nylon ring. Heat, chlorine, salt water and time make them shrink and crack. A watch that was water resistant five years ago may not be today.

Every time we change a battery we look at the case back gasket and replace it if it is flat or cracked. A pressure test after a battery change costs $10 and takes fifteen minutes, while you wait.

If water gets in

Fog under the crystal means moisture is inside. Do not open the watch at home and do not put it on a radiator. Bring it in the same day if you can: we open it, dry the movement and check for rust before it spreads.